|
NLC-ACEIII |
 |
| |
 |
| datasheet |
|
|
NAELCOM has produced a new GPS receiver board,
the “NLC-ACEIII”,
which is based on the Copernicus™ high
performance GPS chip set. |
| This OEM module is designed for use in embedded and industrial applications
requiring high accuracy positioning and timing information. |
| It can also be used as a replacement and upgrade for users of the Trimble
ACE II and ACE III receiver
board. |
| The NLC-ACEIII board is RoHS (lead free) compliant. |
- Ultra-high sensitivity of -160dBm (-190dBw), enabling high
performance acquisition and tracking in urban canyon and signal obscured
environments.
- SBAS support (WAAS, EGNOS), for improved Horizontal and Altitude accuracy.
- Cold Start Time to First Fix (TTFF) is quicker than 38s.
- Low power consumption: 45mA @5V, with Power-Good LED.
- The 2 ports that can be configured to suit the customer’s
requirements such as: input and output protocols (TSIP, NMEA, TAIP)
and transmission speed.
- Configuration parameters backed-up to an EEPROM.
- Pin to pin compatible with Trimble ACE II and ACE III GPS
receivers; same form factor, for ease of integration.
- Protection against open and/or short circuit on the antenna (60mA),
and alarms reported through serial port.
- 50V Overvoltage protection on Antenna input.
- Accurate pps (pulse per second signal), better than 60ns.
- New stationary mode for timing application..
|
The NLC-ACEIII board has successfully completed compliance testing in
accordance with the  directive. |
| Factory setting of the two ports |
| The two communication ports are set as standard as follows: |
Port |
Protocol
|
Baud rate
|
Data bits
|
Parity |
Stop bits
|
Port1 |
TSIP |
38400 |
8 |
None |
1 |
Port2 |
NMEA |
4800 |
8 |
None |
1 |
| NLC-ACEIII Technical Data |
| Performance Specifications |
| Receiver : |
12-channel, continuous tracking receiver |
| Sensitivity: |
Tracking: –160 dBm
Acquisition (High "Indoor" Sensitivity mode): –148 dBm*
Acquisition (Standard Sensitivity Mode)**: -142 dBm |
| Accuracy: |
Horizontal: <2.5 meters (50%), <5 meters (90%)
Horizontal with SBAS: <2 meters (50%), <4 meters (90%)
Altitude: <5 meters (50%), <8 meters (90%)
Altitude with SBAS: <3 meters (50%), <5 meters (90%)
Velocity: 0.06 m/sec
PPS (Static): ±60 nanoseconds rms
PPS (Stationnary Mode "Indoor" @ -145dBm): ±350 nanoseconds
rms
Receiver Dynamics Limit @ -144 dBm: 2G*** |
| Acquisition: |
Hot start: 3 seconds
Warm start: 35 seconds
Cold start: 38 seconds |
| Reacquisition: |
2 seconds (after signal loss) |
* For Hot Start with ephemeris, otherwise
-146dBm.
** Standard Acquisition Sensitivity is the default setting. High mode should
be enabled for indoor applications.
*** Receiver Dynamic Limit is 4G in open sky, Air Mode |
| Environmental Specifications |
| Operating temp: |
–40°C to +85°C |
| Storage temp: |
–55°C to +105°C |
| Electrical Charactistics: |
| Prime power: |
4.5VDC to 5.5VDC
Power consumption: 45mA |
| Antenna voltage |
5VDC, 3.3VDC or passive |
| Interface Charactistics: |
| Serial ports: |
2 serial ports |
| Supported Protocols: |
TSIP, TAIP, NMEA 0183 v3.0
Bi-directional NMEA messages
Messages
selectable by NMEA commands
Selection stored in flash memory |
| Physical Characteristics : |
 |
|
