NAELCOM
ACCUEIL L'ENTREPRISE ACTUALITE CONTACTS
GPS/GSM USB PCMCIA Cartes de communication Cartes mémoires Flash
Stockage OEM Modules DRAM Composants mémoires Programmateurs Service programmation
 
Solutions GPS
 
RECEPTEURS

TIMING

BOITIERS GPS

ANTENNES

ACCESSOIRES

 
Solutions sans fil
 
Modules GPRS

Modules EDGE

Contrôleurs wireless

NLC-RSMT
Produit Naelcom

NLC-RSMT
Introduction
NAELCOM has produced a new Timing GPS receiver board, the “NLC-RSMT”, which is based on the Resolution SMT high performance Timing chip set.
This OEM module is designed to provide accurate timing information.
The NLC-RSMT module is RoHS (lead free) compliant.



Advantages
  • Ultra-high sensitivity of -160dBm.
  • Accurate 1 PPS or even second output, synchronized to GPS or UTC within 15ns.
  • Automatic self-survey.
  • T-RAIM Timing Receiver Autonomous Integrity Monitoring provides high PPS integrity.
  • Low power consumption: 100mA @ 3V.
  • The 2 ports that can be configured to suit the customer’s requirements such as: input and output protocols and transmission speed.
  • Supports 3V or 5V Antennas.
  • TSIP and NMEA protocols.

Factory setting of the two ports
The two communication ports are set as standard as follows:


Port
Protocol
Baud rate
Data bits
Parity
Stop bit
Port1
TSIP
9600
8
Odd
1
Port 2*
NA
NA
NA
NA
NA

*Port 2 must be enabled by software command if needed.

Data connector pinout
8 pin 2mm male header:


Pin number
Function
Description
1
Antenna Power Input
3.0VDC to 5.5VDC
2
Prime Power Input
3.0VDC to 3.6VDC
3
TXD A
Serial Port A transmit, 3.3V TTL CMOS
4
TXD B
Serial Port B transmit, 3.3V TTL CMOS
5
RXD A
Serial Port A receive, 3.3V TTL CMOS
6
1 PPS
3.0V CMOS compatible
7
RXD B
Serial Port B receive, 3.3V TTL CMOS
8
GND
Ground, Power and Signal

NLC-RSMT Technical Data

Performance Specifications
Sensitivity: Tracking: –160 dBm
Acquisition: –155 dBm (with A-GPS)
Environmental Specifications
Operating temp: –40°C to +85°C
Vibration: 0.008 g²/Hz 5 Hz to 20 Hz
0.05 g²/Hz 20 Hz to 100 Hz
-3 dB/octave 100 Hz to 900 Hz
Operating Humidity: 5% to 95% R.H. non-condensing, at +60° C
Electrical Characteristics
Prime power: +3.0VDC to 3.6VDC
Power consumption: 100mA @3.3V
Ripple Noise: Max 50mV, peak-to-peak from 1Hz to 1MHz
Interfaces Characteristics
Connections: I/O: 8-pin (2x4) 2mm Male Header
RF: Right-angle SMB
Serial ports 2 serial ports
PPS/Even second: CMOS-compatible, TTL-level pulse, once per second
Supported Protocos TSIP, NMEA 0183
Bi-directional NMEA messages
Messages selectable by NMEA commands
Selection stored in flash memory
Physical Characterisitcs
dimensions

© Naelcom 2010 - Conditions Générales de Ventes - Haut de la page